Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies >

G47770 - False Clamp Pin (40 mm or 1.58" long)
G47770 - False Clamp Pin (40 mm or 1.58" long)
 
Our Price: USD$13.70


Availability:: Usually Ships in 24 Hours
Product Code: G47770

Description
 
Please Note: This False Clamp Pin requires the Anvil or our False Clamp Pin Tool for proper installation. See G36095-False Clamp Pin Tool or G47768 - Anvil for False Clamp Pin
Features
This false clamp pin is for use on Polar paper cutters and is equivalent to Polar part #232338. It is 40 mm (1.58") long and notched as shown with flats cut on both sides of the large diameter area of the shank. It fits all models of the newer Polar guillotine paper cutters (those made after approximately 1985).


These quality false clamp pins are made in the USA.

For installation, the underside of the original pin must be drilled or ground off, then the pin can be knocked out with a hammer and punch. After inserting a new pin, the bottom end of the pin gets hammered or peened over to install in your Polar false clamp.

Also see our G47769 - False Clamp Pin for false clamp pins that were used on earlier Polar cutters, generally pre-1985.


Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies
Services > False Clamp Repair & Fabrication
Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Polar Clamp Area Parts

Product price is not filled in. This product cannot be purchased.



G33997 - Clutch Handle for Polar 82EL USD$48.00 Each
G22682 - Replaced By: G20569 - Deluxe Part #3267314