Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides >

G16005 - Guide Shaft for Pull Arm in Polar 115 CE Paper Cutters
G16005 - Guide Shaft for Pull Arm in Polar 115 CE Paper Cutters
 
Our Price: USD$115.00


Availability:: Usually Ships in 24 Hours
Product Code: G16005

Description Technical Specs
 
G16005 - Guide Shaft for Pull Arm in Polar 115 CE Paper Cutters
Features
Guide shaft or guide rod for the center of the pull arm on Polar 115 EL, 115 CE and 115 EMC 1 paper cutters (original Polar part number 221717). This 14mm diameter alignment rod fits up the middle of the pull arm to prevent it from flapping around and causing damage when the shear bolts break. It is made from centerless ground drill rod for maximum toughness. Its overall length is approximately 15" long.

This fits 115 EL, CE and EMC 1 cutters made after machine serial number 4731747, or earlier models that have had their original roll pin mounting hole drilled and tapped out to use a set screw.

If your pull arm uses a roll pin to lock the bottom of the guide rod in place then you need our part number G16006.


Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides

Product price is not filled in. This product cannot be purchased.



G23487 - Replaced By: CR0036 - Deluxe Part #902-1096
G48809 - Key - S5B54S - Deluxe Part #CB1606 USD$180.00
Wire-O Binding [7/16", Red, 32 Loop 3:1 Pitch] Box 100 USD$27.38
G21741 - Stationary Cutter 5/8 - Deluxe Part #15600-25 USD$31.70
G44977 - Cutter Box Assembly, HSS-HK with #3157231 Cutter Mount Plate - Hohner Part #9957207 USD$1,244.30
Spiral Plastic Coil 5:1 36" [14 mm (9/16"), Red] Box 100 USD$63.44
G14955 - Shaft-Jog - Deluxe Part #RBM1626F USD$209.00
G11728 - Adjuster Block - Deluxe Part #CA9646 USD$23.50
G12440 - Top Wire Guide Plate - Deluxe Part #CB50 USD$78.70