 |
 |
 |
 |
|
 |
|
Features
Slot covering belt or table slot cover tape for the later models of the Polar 92 S, Polar 92 E, and Polar 92 ED paper cutters. This belt fits cutters built after machine serial number 6401101. Also fits Polar 92 X, Polar 92 XT, and Polar 92 N models. (Always check your parts book before ordering. There are many variations with these belts. The original part number is usually located on page 20.22 of the Polar parts books.)
This green table slot cover band or back gauge belt is equivalent to, and a direct replacement for, the original Polar part number 033956 and ZA3.033956. It is an aftermarket belt which is made from the same material as the original. It contains the center "V" guide which is fused to the belt.
Measures 60 mm wide (2 3/8" wide) by 1.25mm thick (.050" thick). The cogged center "V" guide is 10 mm wide. As shown in the photo, one end has the mounting slots cut out, the other end has the two mounting grommets installed.
For earlier Polar 92 slot covering belts, see our part number G53749
|
|
|
|
|
|
|
