Home > Die Cutting and Letterpress > Die Cutting And Letterpress Parts And Supplies > Kluge Parts >

Kluge Side Arm Blocks
Kluge Side Arm Blocks
 
Our Price: USD$350.00


Product Code: G36036

Description
 
Replaces the original Die Cutting Dwell Spacers that mushroom out over time and require maintenance. Modern foils no longer require the dwell mechanism so most operators leave these in the machine permanently for die cutting, foil, embossing, etc.
Features
Replaces the original cylindrical die cutting spacer that wears out and requires regular re-leveling of the platen to compensate for their wear.

A matched pair.

For EHD and EHE models.

Here are some heavily-mushroomed spacers

Note the wear in the bearing blocks too

Easy to replace-
1) Do one arm at a time. Loosen the setscrews for the two guide rods and the thinner center rod and pull them all out. The center rod will no longer be used so it can be put away.
2) Remove the springs, the spring spacers inside of the springs, and the dwell spacer.
3) Slide the block in between the old shim plates. You can stack the shim plates together if you wish, they don't need to be on either side of the block like the old spacer needed to be.
4) Slide the guide rods through the shims and block down to the original position and re-tighten the set screws.

It is very likely that your old spacers were unevenly worn and often the bushing block was also damaged so the platen may need to be re-leveled.


Browse for more products in the same category as this item:

Die Cutting and Letterpress > Die Cutting And Letterpress Parts And Supplies > Kluge Parts
Die Cutting and Letterpress > Die Cutting And Letterpress Parts And Supplies > Kluge Parts > View All Kluge Parts

Product price is not filled in. This product cannot be purchased.



G39637 - Driving Slide S-50 - Deluxe Part #OSK102M USD$301.00
G25321 - Blade/Challenge/13.000" LG x 5.000" WD x .500" TK/4 Holes/Three Knife Trimmer Front/HSS Inlay/Challenge Part #6248/Each USD$408.50 Each
G33705 - Padding Brush 2" Wide USD$2.95
Pump Rebuild Kit, TR-81-DV/DVV /Elmo Rietschle Part #3152/Use #3121 USD$860.00
G50331 - DO NOT USE, New #9959508 March 2003 SN 4437 up to 5531 - Hohner Part #9959635
G25314 - Hex Nut Guide Stud - Deluxe Part #G30024B USD$32.80
G11277 - Replaced By: 070000 - Deluxe Part #0881.0379.1
G39705 - Upper Wire Tube S50 - Deluxe Part #OSK121M USD$22.30
Bostitch Model 2 Stitcher USD$300.00