G16001 - Guide Shaft for Pull Arm in Polar 80 EL Paper Cutter

Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides >

Our Price: USD$78.00

Availability:: Usually Ships in 24 Hours
Product Code: G16001

Description

Technical Specs

G16001 - Guide Shaft for Pull Arm in Polar 80 EL Paper Cutter

Features
Guide shaft or guide rod for the center of the pull arm on Polar 80 EL paper cutters. This 11mm diameter alignment rod fits up through the center of the pull arm to prevent it from flapping around and causing damage when the shear bolts break. It is made from centerless ground drill rod for maximum toughness. Overall length is approximately 11" long. This guide shaft is held in place with a dowel pin. The guide shaft must be drilled in place to install it. Many cutter rebuilders will tap out the dowl pin hole in the lower arm and install a set screw. This will prevent having to drill out the guide shaft each time it is replaced.

Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides

	Shaft Support/Full Circle Upper/Rosback 240-A-069 (Replaces Rosback 223-026A - No longer available - need two, one for upper and one for lower shaft] - USD$240.13