G16005 - Guide Shaft for Pull Arm in Polar 115 CE Paper Cutters

Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides >

Our Price: USD$115.00

Availability:: Usually Ships in 24 Hours
Product Code: G16005

Description

Technical Specs

G16005 - Guide Shaft for Pull Arm in Polar 115 CE Paper Cutters

Features

Guide shaft or guide rod for the center of the pull arm on Polar 115 EL, 115 CE and 115 EMC 1 paper cutters (original Polar part number 221717). This 14mm diameter alignment rod fits up the middle of the pull arm to prevent it from flapping around and causing damage when the shear bolts break. It is made from centerless ground drill rod for maximum toughness. Its overall length is approximately 15" long.

This fits 115 EL, CE and EMC 1 cutters made after machine serial number 4731747, or earlier models that have had their original roll pin mounting hole drilled and tapped out to use a set screw.

If your pull arm uses a roll pin to lock the bottom of the guide rod in place then you need our part number G16006.

Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides

Product price is not filled in. This product cannot be purchased.

	G48867 - Replaced By: CB759 - Deluxe Part #D30421F
	G33495 - Wire tube, lower 70/20 - Hohner Part #9467222 USD$162.30
	G52243 - Yellow Vinyl Sucker 9/16H X 3/4W X 1/4B - Hohner Part #4210146 USD$9.90
	G32243 - Bearing Bolt, 48/5 & 52/8 - Hohner Part #3263122 USD$15.70
	G51177 - Bearing Bolt, HSS-18 1 Way System - Hohner Part #3156106 USD$30.80
	G33019 - Screw, pan head: DIN 84: 3x12mm - Hohner Part #7203012 USD$2.90
	G25166 - Pivot Block 5/8 Cr, G20 - Deluxe Part #G20643 USD$228.00
	G51187 - Spacer, Feed Wheel , HSS-18 Old Style - Hohner Part #3156129 USD$28.20
	G51133 - Plate, LH side frame - Hohner Part #3118001 USD$830.50