Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides >

G16007 - Guide Shaft for Pull Arm in Polar 115 EL & 115 EMC Paper Cutters
G16007 - Guide Shaft for Pull Arm in Polar 115 EL & 115 EMC Paper Cutters
 
Our Price: USD$115.00


Availability:: Usually Ships in 24 Hours
Product Code: G16007

Description
 
G16007 - Guide Shaft for Pull Arm in Polar 115 EL & 115 EMC Paper Cutters
Features

Guide shaft or guide rod for the center of the pull arm on early Polar 115 CE and 115 EL cutters, built before machine serial number 4731747. These early Polar 115 EL and 115 CE are the ones that use 2 shear bolts in the pull arm and use a roll pin to secure the bottom of the guide rode in place.

If your pull arm uses a set screw to mount the guide rod in place then see our part number G16005

The later 115 EMC 2 cutters (after about 1984) have a single center shear bolt and use our part number G16008

This 14mm diameter alignment rod fits up the middle of the pull arm to prevent it from flapping around and causing damage when the shear bolt breaks. It is made from centerless ground drill rod for maximum toughness. Overall length is approximately 15" long. (original Polar part number 207463 or 218649)


Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides

Product price is not filled in. This product cannot be purchased.

Product price is not filled in. This product cannot be purchased.



G54306 - Replaced By: CB835R - Deluxe Part #D31803F
G34787 - Slitter Blades USD$51.00
G23543 - Face Plate Clamp Block Nut - Deluxe Part #9056N USD$2.55
Stitcher Head Assembly - 21X25 Wire 7/16 Cr - Deluxe Part #G5MXHD21251/2-NP USD$2,110.00
G22983 - Supporter Screw - Deluxe Part #7245 USD$12.50
G52231 - DO NOT USE- See Part #9461312 - Hohner Part #3763311
G23510 - Replaced By: CA9035 - Deluxe Part #9035
G52630 - Base Washer - Hohner Part #3763152 USD$17.20
G40505 - Stitching Wire/Flat/20 x 24 Gauge/On 5 lb. Spool/Tinned/Per Spool USD$20.25 Per Case of Ten Spools