Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies >

G47769 - False Clamp Pin (47mm or 1.85" Long)
G47769 - False Clamp Pin (47mm or 1.85" Long)
 
Our Price: USD$13.70


Availability:: Usually Ships in 24 Hours
Product Code: G47769

Description
 
Please Note: This False Clamp Pin requires the Anvil for proper installation. See G47768 - Anvil for False Clamp Pin
Features
This false clamp pin is for use on Polar guillotine paper cutters. It is equivalent to Polar part #206035. It is 47mm (1.85") long and is notched for the latch pin, as shown in the photo. It is used in all Polar cutters built before approximately 1985.

These quality false clamp pins are made in the USA.

For installation, the underside of the original pin must be drilled or ground off, then the pin can be knocked out with a hammer and punch. After inserting a new pin, the bottom end of the pin gets hammered or peened over to install in your Polar false clamp.

See our part # G47770 - False Clamp Pin for the false clamp pin used after approximately 1985.


Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies
Services > False Clamp Repair & Fabrication
Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Polar Clamp Area Parts


G25342 - Teflon Bearing 3/8x1/2 - Deluxe Part #G30050 USD$11.50
G23962 - Hollow Drill Bit/Lawson-Seybold/Long Drill/7/16" Dia/3" Capacity/Uncoated USD$26.98 Each
G26199 - Blade/Baumfolder/34-3/4" LG x 4" WD x 3/8" TK/For 305/HSS Inlaid/Each USD$470.25 Each
G14520 - Stitcher Head Assembly - Bonelli - Deluxe Part #G8BNHD241/2 USD$2,230.00
G32679 - Ball joint - Hohner Part #4200004 USD$1,500.40
G21086 - Screw M5x0.8x8 (Replaces 0030.0030) - Deluxe Part #042001 USD$1.15
G34307 - timing belt RPP5 - Hohner Part #4200985 USD$39.60
G52091 - Bonnet Assembly - G8, Hybar Wire - Deluxe Part #G20000TA USD$966.00
G50586 - See Part #9456525 - Hohner Part #9200111