G16005 - Guide Shaft for Pull Arm in Polar 115 CE Paper Cutters

Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides >

Our Price: USD$115.00

Availability:: Usually Ships in 24 Hours
Product Code: G16005

Description

Technical Specs

G16005 - Guide Shaft for Pull Arm in Polar 115 CE Paper Cutters

Features

Guide shaft or guide rod for the center of the pull arm on Polar 115 EL, 115 CE and 115 EMC 1 paper cutters (original Polar part number 221717). This 14mm diameter alignment rod fits up the middle of the pull arm to prevent it from flapping around and causing damage when the shear bolts break. It is made from centerless ground drill rod for maximum toughness. Its overall length is approximately 15" long.

This fits 115 EL, CE and EMC 1 cutters made after machine serial number 4731747, or earlier models that have had their original roll pin mounting hole drilled and tapped out to use a set screw.

If your pull arm uses a roll pin to lock the bottom of the guide rod in place then you need our part number G16006.

Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides

Product price is not filled in. This product cannot be purchased.

	G39705 - Upper Wire Tube S50 - Deluxe Part #OSK121M USD$22.30
	G54007 - Clincher Points, Brochure Multinak Stapler - Hohner Part #2939130 - Discontinued
	G50413 - Flat Belt HSB7000 - Hohner Part #3149811 USD$130.00
	G54331 - Post Stitcher, 7/16 Cr, 16 inch throat, (.103X.020 Wire) - 18 in Ext Height - Deluxe Part #HF16P-AST-EX18 USD$12,960.00
	G12596 - Driver Bar Tee Stud - Deluxe Part #CB709 USD$29.30
	G12435 - Replaced By: CB4H - Deluxe Part #CB4F
	G52257 - DO NOT USE- See Part No. 3265018 - Hohner Part #6105018
	G12562 - Screw, 1/4-20 X 1-1/2 - Deluxe Part #CB629C USD$2.45
	G44331 - Compression Block - Hohner Part #3167246 USD$145.20