Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies >

G47769 - False Clamp Pin (47mm or 1.85" Long)
G47769 - False Clamp Pin (47mm or 1.85" Long)
 
Our Price: USD$13.70


Availability:: Usually Ships in 24 Hours
Product Code: G47769

Description
 
Please Note: This False Clamp Pin requires the Anvil for proper installation. See G47768 - Anvil for False Clamp Pin
Features
This false clamp pin is for use on Polar guillotine paper cutters. It is equivalent to Polar part #206035. It is 47mm (1.85") long and is notched for the latch pin, as shown in the photo. It is used in all Polar cutters built before approximately 1985.

These quality false clamp pins are made in the USA.

For installation, the underside of the original pin must be drilled or ground off, then the pin can be knocked out with a hammer and punch. After inserting a new pin, the bottom end of the pin gets hammered or peened over to install in your Polar false clamp.

See our part # G47770 - False Clamp Pin for the false clamp pin used after approximately 1985.


Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies
Services > False Clamp Repair & Fabrication
Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Polar Clamp Area Parts


G25624 - Dowel Pin M6x20 - Deluxe Part #G40751 USD$3.70
G12673 - Adjusting Screw - Deluxe Part #CB84 USD$2.45
Micro-perf Heads 54 tpi/Rosback 242-A-050 USD$766.48
G21083 - Former RH 25-28 Wire, DB45 (Replaces 0305.2014.4) - Deluxe Part #040548-25 USD$131.00
G13324 - Clevis 460 Series - Deluxe Part #CK146 USD$29.70
Spiral Plastic Coil 5:1 12" [15 mm (19/32"), Red] Box 100 USD$31.94
G16014 - Seybold Knife Changing Handle USD$31.00 Each
G22871 - Driver Bar Pin - Right - Deluxe Part #7096 USD$6.40
G31015 - Adjusting Block Retaining Pin - Reconditioned - Challenge Part #4427 USD$15.00