G47769 - False Clamp Pin (47mm or 1.85" Long)

Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies >

Our Price: USD$13.70

Availability:: Usually Ships in 24 Hours
Product Code: G47769

Description

Please Note: This False Clamp Pin requires the Anvil for proper installation. See G47768 - Anvil for False Clamp Pin

Features
This false clamp pin is for use on Polar guillotine paper cutters. It is equivalent to Polar part #206035. It is 47mm (1.85") long and is notched for the latch pin, as shown in the photo. It is used in all Polar cutters built before approximately 1985.

These quality false clamp pins are made in the USA.

For installation, the underside of the original pin must be drilled or ground off, then the pin can be knocked out with a hammer and punch. After inserting a new pin, the bottom end of the pin gets hammered or peened over to install in your Polar false clamp.

See our part # G47770 - False Clamp Pin for the false clamp pin used after approximately 1985.

Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies
Services > False Clamp Repair & Fabrication
Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Polar Clamp Area Parts

Product price is not filled in. This product cannot be purchased.

	G14827 - Nut, PVC 1/4-20 - Deluxe Part #RBM1362F USD$3.60
	G43930 - MBO Drive Belt for T47/T49 Folder 25 x 1.3 x 1750 - MBO Part #0105643 USD$85.00
	G23763 - Foot Pad - Deluxe Part #A1004 USD$25.30
	G11780 - Bender Bar Sub-Assembly, Loop - Deluxe Part #CAA9013X3 USD$182.00
	206 Composition Cover [8-1/2" X 11", Royal Blue, Square Corner, NoW indow, 11-hole]Pack 100 USD$70.95
	G32149 - Bearing holder, clincher drive, Orion - Hohner Part #3240316 USD$130.20
	G39098 - Replaced By: H20124 - Deluxe Part #3263009
	G21081 - Wire Holder Assembly, DB45 (Replaces 0305.2042.3) - Deluxe Part #040543A USD$609.00
	G12207 - Pin - Deluxe Part #CB2170 USD$5.40