Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies >

G47769 - False Clamp Pin (47mm or 1.85" Long)
G47769 - False Clamp Pin (47mm or 1.85" Long)
 
Our Price: USD$13.70


Availability:: Usually Ships in 24 Hours
Product Code: G47769

Description
 
Please Note: This False Clamp Pin requires the Anvil for proper installation. See G47768 - Anvil for False Clamp Pin
Features
This false clamp pin is for use on Polar guillotine paper cutters. It is equivalent to Polar part #206035. It is 47mm (1.85") long and is notched for the latch pin, as shown in the photo. It is used in all Polar cutters built before approximately 1985.

These quality false clamp pins are made in the USA.

For installation, the underside of the original pin must be drilled or ground off, then the pin can be knocked out with a hammer and punch. After inserting a new pin, the bottom end of the pin gets hammered or peened over to install in your Polar false clamp.

See our part # G47770 - False Clamp Pin for the false clamp pin used after approximately 1985.


Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies
Services > False Clamp Repair & Fabrication
Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Polar Clamp Area Parts


G24496 - Feed Clutch Arm Assembly - Deluxe Part #D30235A USD$438.00
G26538 - Gripper Spring Pivot Screw - Deluxe Part #UA4041.1 USD$61.30
Die, Tornado Ex 5MM Round/ T8B60 USD$4,950.00
Large Laminating Pouches [6" X 9", Clear Gloss, 7mil] Pack 100 USD$16.86
G22983 - Supporter Screw - Deluxe Part #7245 USD$12.50
G14857 - Shaft (B1000) - Deluxe Part #RBM1438F USD$23.30
G21806 - Work Table Nut - Deluxe Part #17151 USD$14.20
G25977 - Bender Slide - McCain - Deluxe Part #HS-516B USD$136.00
G41252 - Loop Stitch Conversion "7mm" 52/8 - Hohner Part #0552944 - Discontinued