Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies >

G47769 - False Clamp Pin (47mm or 1.85" Long)
G47769 - False Clamp Pin (47mm or 1.85" Long)
 
Our Price: USD$13.70


Availability:: Usually Ships in 24 Hours
Product Code: G47769

Description
 
Please Note: This False Clamp Pin requires the Anvil for proper installation. See G47768 - Anvil for False Clamp Pin
Features
This false clamp pin is for use on Polar guillotine paper cutters. It is equivalent to Polar part #206035. It is 47mm (1.85") long and is notched for the latch pin, as shown in the photo. It is used in all Polar cutters built before approximately 1985.

These quality false clamp pins are made in the USA.

For installation, the underside of the original pin must be drilled or ground off, then the pin can be knocked out with a hammer and punch. After inserting a new pin, the bottom end of the pin gets hammered or peened over to install in your Polar false clamp.

See our part # G47770 - False Clamp Pin for the false clamp pin used after approximately 1985.


Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies
Services > False Clamp Repair & Fabrication
Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Polar Clamp Area Parts

Product price is not filled in. This product cannot be purchased.



Caliper Roller/Rosback 220-A-036 USD$58.96
G25285 - Stitcher Head Assembly, Solid Clincher Plate - Deluxe Part #G20SHD241/2-SCP USD$4,250.00
G51500 - Extension Spring, HSS-18 - Hohner Part #3956223 USD$16.60
G23696 - Replaced By: CAA9526 - Deluxe Part #9526A
G21968 - Adjusting Link Assembly - Left - Deluxe Part #18333A USD$1,360.00
G11648 - Swivel Safety Pin - Deluxe Part #CA9042 USD$3.10
3:1 Square Oversized Rhin-O-Tuff Metal Wire Die USD$1,514.00
Secondary Drive Chain/Rosback 220-A-100 USD$73.81
G48034 - Feed Wheel 52/8 Driven textured surface to assist with wire slippage - Hohner Part #3162763 USD$148.90