Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides >

G16000 - Guide Shaft for Pull Arm in Polar Power Max 28" Paper Cutters
G16000 - Guide Shaft for Pull Arm in Polar Power Max 28" Paper Cutters
 
Our Price: USD$68.00


Availability:: Usually Ships in 24 Hours
Product Code: G16000

Description
 
G16000 - Guide Shaft for Pull Arm in Polar Power Max 28" Paper Cutters
Features
Guide shaft or guide rod for the center of the pull arm on Polar Power Max 28 (PM28), and Polar 72 CE paper cutters built BEFORE machine serial number 4651339. For 72 CE cutters built after machine serial number 4651339 see our part number G15999. Equivalent to Polar part number 219561.

This 10mm diameter alignment rod fits up through the center of the pull arm to prevent it from flapping around and causing damage when the shear bolts break. It is made from centerless ground drill rod for maximum toughness. Overall length is approximately 6-3/4" long


Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides

Product price is not filled in. This product cannot be purchased.



G32197 - Axle, Rocking Yoke - Hohner Part #3253008 USD$35.40
G32756 - Contactor, 250 Volt - Hohner Part #4300077 USD$461.10
G44608 - Gasket disc - Hohner Part #3203265 USD$7.90
G14609 - Motor Assembly, 115V - Deluxe Part #MG10006A USD$893.00
G21026 - Replaced By: 047008 - Deluxe Part #0305.2030.4
Grease Cartridge/14 oz./Mobil AW2 replaced by XHP222/Each USD$14.50
G44088 - Face Plate Assembly, Inverted, S5PO, R1H4 .028 X .103 Arcuate - Deluxe Part #CDDD1275F USD$9,230.00
G24141 - Screw 1/4-20x5/8 - Deluxe Part #AF103 USD$1.70
G14271 - Feed Idler Lever Assembly, S5F Face Plate - Deluxe Part #D38679A USD$339.00