Home > Die Cutting and Letterpress > Die Cutting And Letterpress Parts And Supplies > Kluge Parts >

Kluge Side Arm Blocks
Kluge Side Arm Blocks
 
Our Price: USD$350.00


Product Code: G36036

Description
 
Replaces the original Die Cutting Dwell Spacers that mushroom out over time and require maintenance. Modern foils no longer require the dwell mechanism so most operators leave these in the machine permanently for die cutting, foil, embossing, etc.
Features
Replaces the original cylindrical die cutting spacer that wears out and requires regular re-leveling of the platen to compensate for their wear.

A matched pair.

For EHD and EHE models.

Here are some heavily-mushroomed spacers

Note the wear in the bearing blocks too

Easy to replace-
1) Do one arm at a time. Loosen the setscrews for the two guide rods and the thinner center rod and pull them all out. The center rod will no longer be used so it can be put away.
2) Remove the springs, the spring spacers inside of the springs, and the dwell spacer.
3) Slide the block in between the old shim plates. You can stack the shim plates together if you wish, they don't need to be on either side of the block like the old spacer needed to be.
4) Slide the guide rods through the shims and block down to the original position and re-tighten the set screws.

It is very likely that your old spacers were unevenly worn and often the bushing block was also damaged so the platen may need to be re-leveled.


Browse for more products in the same category as this item:

Die Cutting and Letterpress > Die Cutting And Letterpress Parts And Supplies > Kluge Parts
Die Cutting and Letterpress > Die Cutting And Letterpress Parts And Supplies > Kluge Parts > View All Kluge Parts


G51004 - Hydraulic Clamp Cylinder - Rebuilt w/Core Exchange - Same as Challenge #A-8411 USD$750.00 ($600 plus $300 Refundable Core Chg)
G23115 - Hollow Drill Bit/For Iram-Sterling Drills/Long Length/3" Capacity/5/16" Diameter/Uncoated USD$34.19 Each
G50317 - Cutter Box, 43/6S New Dec 2008 - Hohner Part #3164279 USD$279.60
G25657 - Screw M6x1.0x16 - Deluxe Part #G40803 USD$1.15
Martin Yale Blade/22.441" L x 3.543" W x .394" Tk/MRO620RC02/10 Holes/Standard Inlaid/Each USD$285.00 Each
G33663 - Clincher Box Assy 22 Horizon SPF30-20 - Hohner Part #9963685 USD$598.00
G34282 - Driver -L- Hohner Part #3164408 USD$251.80
G54301 - Stitch Head 1/2 Cr, 25 Rd Wire, M2000 - Indiana Ribbon - Deluxe Part #CTTT2605P11 USD$1,290.00
G32267 - Roller, Rocking Yoke - Hohner Part #3265006 USD$79.30