G16007 - Guide Shaft for Pull Arm in Polar 115 EL & 115 EMC Paper Cutters

Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides >

Our Price: USD$115.00

Availability:: Usually Ships in 24 Hours
Product Code: G16007

Description

G16007 - Guide Shaft for Pull Arm in Polar 115 EL & 115 EMC Paper Cutters

Features

Guide shaft or guide rod for the center of the pull arm on early Polar 115 CE and 115 EL cutters, built before machine serial number 4731747. These early Polar 115 EL and 115 CE are the ones that use 2 shear bolts in the pull arm and use a roll pin to secure the bottom of the guide rode in place.

If your pull arm uses a set screw to mount the guide rod in place then see our part number G16005

The later 115 EMC 2 cutters (after about 1984) have a single center shear bolt and use our part number G16008

This 14mm diameter alignment rod fits up the middle of the pull arm to prevent it from flapping around and causing damage when the shear bolt breaks. It is made from centerless ground drill rod for maximum toughness. Overall length is approximately 15" long. (original Polar part number 207463 or 218649)

Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Gearbox, Flywheel And Pull Arm Area Parts > Pull Arm Guides

Product price is not filled in. This product cannot be purchased.

	G44234 - Roller Guide - Hohner Part #3118532 USD$385.20
	G11304 - Replaced By: CTTT2605P2 - Deluxe Part #2601ABGHD251/2-EXT
	Padding Brush, 2" Round/Each USD$22.00
	G14992 - Back Cover Welment - Deluxe Part #RBM1676A USD$143.00
	G50332 - DO NOT USE, SEE #9959506 - Hohner Part #9959457
	G24049 - Replaced By: CB60 - Deluxe Part #A302E2
	G50253 - Bender, RH Accord 25/40 Flat Wire - Hohner Part #3141788 USD$361.40
	G32283 - Eccentric Stud, Wire Straightner - Hohner Part #3265208 USD$91.40
	Shrink Bundling Tunnels PP3616-60SBT Call for price