Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies >

False Clamp - 78 Size Polar Models - Narrow Width For Business Cards
False Clamp - 78 Size Polar Models - Narrow Width For Business Cards
Regular width model shown in photo
  
Our Price: USD$850.00


Availability:: Usually Ships in 1 to 2 Weeks
Product Code: G36103

Description
 
G36103 - Narrow width (approx 1.9") for business cards. This version has a 14 mm mounting pin margin**See Important note below!!
Features
Fits on 78 ES, ED, X, XT

This is our business card version which is approximately 1.9" wide so it is narrow enough for cutting business cards. The machine can tell which false clamp you have installed by the height of the third pin and these include the pin for a narrow version. This permits the backgauge to run up to the plate.

**IMPORTANT NOTE!!!: There are at least two versions of False Clamp pin configuration for this size of cutter, and we cannot tell which type you have from your serial number.
The major difference between them is the distance of the center of the mounting pins to the blade-side edge of the plate; with one measuring 14mm (approx. 9/16") which is our Product #G36103 and you are currently on its product page. The other margin is 10mm (approx. 3/8")which is our Product # G36102.



What we can do to confirm which one you have is ship you two miniature Test False Clamps that we have made and then you can tell us which one fits your cutter. We will contact you if you purchase this False Clamp to give you this option if you cannot measure the distance of the holes on your clamp yourself. DO NOT CYCLE THE BLADE WITH THE TEST FALSE CLAMP IN YOUR MACHINE!!

ORDERING INSTRUCTIONS:
Purchase a False Clamp model of your preferred width but in either pin configuration and if you happen to have the other type of pin distance we will adjust the product number on your order.

*Note: More False Clamps for other Polar Cutter sizes may not be on this website but may also be available - Please call to inquire.

These are typically made to order and have a 1 to 2 week lead time. Check with us for current stock.
Note: We can repair False Clamps that have broken or bent pins. Call us for pricing at 1-877-22GODAR.


Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies
Services > False Clamp Repair & Fabrication
Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Polar Clamp Area Parts


G51114 - Enclosure Only For Challenge Part Number E-866-1 USD$49.95
G24973 - Hex Key Wrench 2.5mm - Deluxe Part #G20361 USD$2.50
G32745 - Control light - Hohner Part #4300053 USD$186.20