Home > Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies >

G47769 - False Clamp Pin (47mm or 1.85" Long)
G47769 - False Clamp Pin (47mm or 1.85" Long)
 
Our Price: USD$13.70


Availability:: Usually Ships in 24 Hours
Product Code: G47769

Description
 
Please Note: This False Clamp Pin requires the Anvil for proper installation. See G47768 - Anvil for False Clamp Pin
Features
This false clamp pin is for use on Polar guillotine paper cutters. It is equivalent to Polar part #206035. It is 47mm (1.85") long and is notched for the latch pin, as shown in the photo. It is used in all Polar cutters built before approximately 1985.

These quality false clamp pins are made in the USA.

For installation, the underside of the original pin must be drilled or ground off, then the pin can be knocked out with a hammer and punch. After inserting a new pin, the bottom end of the pin gets hammered or peened over to install in your Polar false clamp.

See our part # G47770 - False Clamp Pin for the false clamp pin used after approximately 1985.


Browse for more products in the same category as this item:

Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies
Services > False Clamp Repair & Fabrication
Cutting, Trimming and Slitting > Paper Cutter Parts > Polar Parts & Supplies > Polar Clamp Area Parts

Product price is not filled in. This product cannot be purchased.



G39825 - Replaced By: 18901 - Deluxe Part #SS363-3
G49933 - thread nipple HSB - Hohner Part #4210137 USD$65.60
G26452 - Kit - Double Head Conversion - Deluxe Part #SMK3 USD$416.00
Die, Tornado Ex Comb/ T3321 0.2 Margin USD$4,950.00
G32345 - DO NOT USE - SEE PART #3155151
G31676 - Former Plate, M50/8 - Hohner Part #3159353 USD$61.10
G12958 - Former & Driver 1/4 Cr, .078 X .022 Glove Job - Deluxe Part #CBBB83W USD$1,250.00
G14992 - Back Cover Welment - Deluxe Part #RBM1676A USD$143.00
G51597 - Spacer, Feed Wheel, HSS-18 - Hohner Part #4400039 USD$8.20