 |
 |
 |
 |
|
 |
|
Features
Slot covering belt or tape for many of the Polar 115 S, 115 E, 115 ES, 115 ED, 115 X, and 115 XT paper cutters. This back gauge belt does not fit cutters with a serial number before 6403101. (Always check your parts book for the original part number before ordering. There are many length variations with these belts. The original part number is usually located on page 20.22 of the Polar parts book.)
This flexible green table slot cover band or slot cover tape is equivalent to, and a direct replacement for, the original Polar part number 033961, 033961N, ZA3.033961, and ZA3.033961N. It is an aftermarket belt which is made from the same material as the original. It contains the center "V" guide which is fused to the belt.
Measures 60 mm wide (2 3/8" wide) by 1.25mm thick (.050" thick). The width at the base of the cogged center "V" guide is 10 mm wide. As shown in the photo, one end has the mounting slots cut out, the other end has the two mounting grommets installed.
|
|
|
|
|
|
|
