Upper Threaded Arm For many Polar 92 EM, EMC and EMC-MON and other 92 size cutters.
Installation notes:
It is highly recommended to always replace the turnbuckle when replacing this part.
The bored-out "eye" end is slightly offset in relation to the threaded shaft.
The side of the "eye" with the raised hub points towards the rear of the machine.
When driving in the roll pin that stops the threaded shaft from coming out of the turnbuckle, be very careful to not over-drive the pin too far to the rear of the turnbuckle. The turnbuckle threads will be ruined and there may be no easy way to remove the pin in this situation.
Always support the turnbuckle from behind with blocks before tapping in the roll pin. Otherwise the threaded shaft may get damaged
|
