Slot covering belt or tape for Polar 155 S, 155 E, and 155 ED paper cutters built after serial number 6502101. This does not fit cutters built before machine serial number 6502101. (Always check your parts book for the original belt part number before ordering. There are many length variations with these belts. The original part number is usually located on page 20.22 of the Polar parts books.)

This green table slot cover band or back gauge belt is equivalent to, and a direct replacement for, the original Polar part number 33965, 033965 and ZA3.033965. This is an aftermarket belt which is made from the same material as the original. It contains the center "V" guide which is fused to the belt.

Measures 60 mm wide (2 3/8" wide) by 1.25mm thick (.050" thick). The cogged center "V" guide is 10 mm wide. As shown in the photo, one end has the mounting slots cut out, the other end has the two mounting grommets installed.